1. Anyone have this spreader bar?

    1530548766
    Richyrichrich [sign in to see picture]
    • Rank: Lieutenant Colonel
    • Posts: 22
    • Joined: 30 Nov 2017

    The OH & I are looking at adding this spreader bar to our
    collection: https://www.lovehoney.co.uk/product.cfm?p=29428 Does
    anyone else have it? Can anyone check the size of the holes in the
    central bar, that's used to change the size? I'm thinking of getting a
    couple of eye bolts to put through those holes to allow the connection
    of some wrist cuffs to that point, but I'd like to check this would be
    possible before buying!

    1530549248
    LIL_KNOWN69 [sign in to see picture]
    • Rank: Field Marshall
    • Posts: 2004
    • Joined: 9 Oct 2005

    Are the O-rings attached to the bolts not able to work for the wrist
    cuffs? Most of the cuffs we have used can easily come apart and lock to
    the central bolt rings ☺️ I believe they are usually a little bit
    thinner than a pencil but someone at customer services may be able to
    let you know. We have a set which is exactly the same but has a cover
    over the top and that has bolt holes around 6mm.

    1530550027
    HFVD [sign in to see picture]
    • Rank: Colonel
    • Posts: 49
    • Joined: 2 Dec 2016

    I don’t have the one listen but have a very similar model in the scandel
    spreader bar. https://www.lovehoney.co.uk/product.cfm?p=39451 The two
    are very similar and I was deciding between that one and the one you’ve
    listed. Very happy with the one I purchased and would highly recommend
    it, love the pattern on it aswell. The holes in the centre bar on the
    scandel spreader bar are 7mm in diameter, I would imagine that they are
    similar on your bar also. Sorry that I couldn’t be more help but I’m
    sure someone will be along soon! :)

    1530550267
    Richyrichrich [sign in to see picture]
    • Rank: Lieutenant Colonel
    • Posts: 22
    • Joined: 30 Nov 2017

    The issue I thought there would be with the locking pins, is they
    would just pull out if you applies too much pressure. I don't have it
    yet, so I don't know for sure, but I was expecting this to be the case.
    I tried CS, but they said they didn't know unfortunatly. I might just
    have to buy it, then experiment from there!

    1530550927
    HFVD [sign in to see picture]
    • Rank: Colonel
    • Posts: 49
    • Joined: 2 Dec 2016

    Yout concern is right richy, the locking pins are easily pulled out so
    wouldn’t be suitable for attaching cuffs to. I purchased the Carrabenas
    from lovehoney but unfortunately these where to big to fit through the
    holes and had to improvise with some eye bolts from a local DIY store.

    1530551524
    Richyrichrich [sign in to see picture]
    • Rank: Lieutenant Colonel
    • Posts: 22
    • Joined: 30 Nov 2017

    Sounds like that's the best way to do it then. What size eye bolts did
    you use? 5/6mm?

    1530552663
    HFVD [sign in to see picture]
    • Rank: Colonel
    • Posts: 49
    • Joined: 2 Dec 2016

    Yep, 6mm ones, then can just clip on the cuffs on and away you go. I
    would imagine the bar you posted is a similar size however I can not be
    certain.

    Post a reply to this thread

    Please sign in to post messages to the forum.